Get the newest Cisco CCNP Data Center 300-165 dumps pdf files and vce youtube demo update free shared. Practice for Cisco 300-160 exam with best Cisco CCNP Data Center 300-165 dumps pdf training resources. “Implementing Cisco Data Center Infrastructure” is the name of Cisco CCNP Data Center exam dumps which covers all the knowledge points of the real Cisco exam. 100% passing guarantee and full refund in case of failure.

Cisco CCNP Data Center 300-165 exam preparation kit contains all the necessary 300-165 questions that you need to know. With the help of latest and authentic Cisco CCNP Data Center 300-165 dumps exam questions, you can find the best Cisco 300-165 exam preparation kit here from lead4pass and you will also get the 100% guarantee for passing the Cisco 300-165 exam.

High Quality Cisco CCNP Data Center 300-165 Dumps Real Exam Questions And Answers (1-30)

Which two options are limitations of NetFlow Version 5? (Choose two.)
A. no support for IPv6, Layer 2, or MPLS fields
B. fixed field specifications
C. excessive network utilization
D. analyzes all packets on the interface
Correct Answer: AB

Which two actions are required before FIPS is configured in Cisco MDS? (Choose two.)
A. Passwords must be a minimum of 10 characters in length.
B. SNMP v2 or v3 must be enabled.
C. Remote authentication must occur utilizing RADIUS/TACACS+.
D. Disable VRRP.
E. Delete all SSH server RSA key pairs.
F. Delete all IKE policies utilizing MD5 or DES for encryption.
G. Enable the FC-FIPS feature.
H. Disable SSH.
Correct Answer: DF

If you are using NAT in your data center, which load balancing would you be likely to use within your GLBP configuration?
A. none
B. round-robin
C. host dependent
D. weighted
Correct Answer: C

Which parameter is configurable when setting up logging on the Connectivity Management Processor?
A. the number of CMP messages to save in a single log file
B. the number of times the log can roll over
C. the directory to save the log file to
D. the severity threshold of the messages to log
Correct Answer: D

Which Cisco NX-OS feature allows transparent Layer 2 extension between sites?
A. FabricPath
D. vPC
F. TrustSec
Correct Answer: C

Which three options of encryption are supported in PIM hello messages? (Choose three.)
A. cleartext
D. Cisco Type 7
Correct Answer: ADF

300-165 dumps Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name vsan <vsan-#> command.
Correct Answer: D

Refer to the exhibit.
300-165 dumps
What is the maximum IPv6 unicast route memory allocated?
A. 4 MB
B. 8 MB
C. 1024 MB
D. 1 GB
E. 5 MB
Correct Answer: A

Refer to the exhibit.
300-165 dumps
Which two outcomes occur when the state is Other? (Choose two.)
A. The VSAN on each end of the connection does not match.
B. The interface is not an E Port.
C. The interface is not an F Port.
D. The interface is administratively shut down.
E. Cisco Fabric Services is not enabled.
F. NPIV should be disabled.
G. The interface is functioning, but may have errors.
H. Encryption is not enabled.
Correct Answer: CD

Which command ensures that a learned MAC address is stored within NVRAM?
A. switchport port-security mac-address address [vlan vlan-ID]
B. switchport port-security
C. switchport port-security mac-address sticky
D. feature port-security
Correct Answer: C

In Cisco Nexus 7000 Series Switches, which three statements about SPAN are true? (Choose three.)
A. SPAN source ports can be the in-band interface to the supervisor engine control plane of the switch.
B. SPAN monitor ports can be routed ports.
C. SPAN destination ports can be configured in only one SPAN session at a time.
D. The Cisco Nexus 7000 supports virtual SPAN feature.
E. SPAN destination port actively participates in spanning-tree instance.
F. SPAN destinations cannot be an RSPAN VLAN.
Correct Answer: ACD

Which four statements about reserved VLANs in Cisco NX-OS are true? (Choose four.)
A. The range of reserved VLANs cannot be changed.
B. The number of reserved VLANs is 96.
C. A change to the range of reserved VLANs can be performed only in the VDC default.
D. A write-erase procedure restores the default reserved VLAN range.
E. The number of reserved VLANs is 128.
F. A reload is needed for changes to take place.
G. The configuration must be saved for changes to take place.
Correct Answer: CEFG

Which three options are capabilities of the Cisco Nexus 7000 Series Switch? (Choose three.)
A. All interface and supervisor modules are accessible from the front.
B. All interface and supervisor modules are accessible from the rear.
C. single power supply only
D. multiple power supply option for redundancy
E. up to 180.7 Tbps forwarding capacity with Fabric-2 modules with 10-slot switches
F. up to 18.7 Tbps forwarding capacity with Fabric-2 modules with 18-slot switches
Correct Answer: ADF

Which command specifies a load-balancing method based on the MAC address of a host where the same forwarder is always used for a particular host while the number of GLBP group members remains unchanged?
A. load-balancing host-dependent
B. load-balancing mac-pinning
C. load-balancing round-robin
D. load-balancing weighted
Correct Answer: A

In OTV, how are the VLANs split when a site has two edge devices?
A. They are configured manually by user.
B. They are split in half among each edge device.
C. They are split as odd and even VLAN IDs on each edge device.
D. It is not possible to have two edge devices in same site.
Correct Answer: C

Which protocol is responsible for the discovery of FCoE capabilities on a remote switch?
Correct Answer: B

Data Center Bridging Capabilities Exchange Protocol (DCBX): a discovery and capability exchange protocol that is used for conveying capabilities and configuration of the above features between neighbors to ensure consistent configuration across the network. This protocol leverages functionality provided by IEEE 802.1AB (LLDP). It is actually included in the 802.1az standard.

Which command enables NPIV on Cisco Nexus 5000 Series Switches and Cisco MDS switches?
A. switch(config)# npiv enable
B. switch(config)# npivon
C. switch(config)# feature npiv
D. switch(config)# npiv proxy
E. switch(config)# np proxy-enable
Correct Answer: C

Which statement about core-edge SAN topology is true?
A. Converged FCoE links connect the core and edge MDS switches.
B. The SAN core connects to the network aggregation layer.
C. Separate links with the same I/O are used for SAN and LAN traffic.
D. Storage devices are accessed via FCoE over the LAN network.
Correct Answer: B

The Aggregation layer of the data center provides connectivity for the Access layer switches in the server farm, an aggregates them into a smaller number of interfaces to be connected into the Core layer. 300-165 dumps In most data center environments, the Aggregation layer is the transition point between the purely Layer 3 routed Core layer, and the Layer 2-switched Access layer. 802.1Q trunks extend the server farm VLANs between Access and Aggregation layers. The Aggregation layer also provides a common connection point to insert services into the data flows between clients and servers, or between tiers of servers in a multi-tier application.

Which configuration is specific to Cisco TelePresence System seed devices?
A. radius server radius-server-name
B. aaa session-id common
C. radius-server vsa send authentication
D. aaa new-model
Correct Answer: A

Which two statements about SAN zoning on Cisco Nexus switches are true? (Choose two.)
A. Unlike configured zones, default zone information is not distributed to the other switches in the fabric.
B. Traffic can either be permitted or denied among members of the default zone. This information is not distributed to all switches. It must be configured in each switch.
C. The settings for default zone configurations cannot be changed.
D. To activate a zone set, you must copy the running configuration to the startup configuration after the zone set is configured.
E. Soft zoning restrictions will not prevent a source device from accessing a device outside its zone, if the source knows the Fibre Channel ID of the destination.
F. Hard zoning is enforced by the hardware on each FLOGI sent by an N Port.
Correct Answer: BE

Each member of a fabric (in effect a device attached to an Nx port) can belong to any zone. If a member is not part of any active zone, it is considered to be part of the default zone. Therefore, if no zone set is active in the fabric, all devices are considered to be in the default zone. Even though a member can belong to multiple zones, a member that is part of the default zone cannot be part of any other zone. The switch determines whether a port is a member of the default zone when the attached port comes up. Unlike configured zones, default zone information is not distributed to the other switches in the fabric Traffic can either be permitted or denied among members of the default zone. This information is not distributed to all switches; it must be configured in each switch.

Which statement describes what happens if a new EPLD version is released with a new Cisco NX-OS version for a Cisco Nexus switch, but these EPLDs are not upgraded at the same time that NX-OS is upgraded?
A. Any new hardware or software feature that depends on the updated EPLD image is disabled until upgraded.
B. Modules that use an updated EPLD image remain offline until the EPLD is upgraded.
C. The EPLD image version mismatch is detected by the supervisor, which automatically initiates an upgrade.
D. The Cisco NX-OS upgrade fails as a result of the mismatch between EPLDs and NX-OS versions.
Correct Answer: A

Which command is used to associate EID-to-RLOC for a LISP site?
A. #feature lisp
B. #ipv6 lisp itr
C. #ip lisp database-mapping
D. #ip lisp itr map-resolver
Correct Answer: C

Which feature must be enabled for Cisco TrustSec FC Link Encryption to work on a Cisco MDS 9000 Series Switch?
A. crypto IKE
B. port security
Correct Answer: D

Which three attributes encompass a local user account on a Cisco NX-OS device? (Choose three.)
A. expiration date
B. cisco-avpair
C. password
D. AAA server address
E. user roles
F. bind user DN
G. user privileges
Correct Answer: ACE

Which command activates the port security database for VSAN 1 regardless of conflicts?
A. port-security commit vsan 1
B. no port-security auto-learn vsan 1
C. port-security activate vsan 1 force
D. port-security database vsan 1
Correct Answer: C

Which three options are capabilities of the Cisco Nexus 7000 Series Supervisor Module? (Choose three.)
A. hardware forwarding on the supervisor module
B. fully decoupled control plane and data plane with no forwarding on the supervisor module
C. Sup2 requires Cisco NX-OS 5.1 or later.
D. Sup2 requires Cisco NX-OS 6.1 or later.
E. Sup2E supports 8+1 VDC with the N7K-VDC1K9 license per chassis.
F. Sup2 supports 8+1 VDCs with the N7K-VDC1K9 license per chassis.
Correct Answer: BDE

Refer to the exhibit.
300-165 dumps
Which two commands are missing from this configuration that an admin needs to integrate a Cisco Nexus 5000 switch with vCenter to leverage VM-FEX? (Choose two.)
A. vmware dvs datacenter-name
B. vmware dvs
C. remote ip address port 80 vrf
D. connection-type vmware
E. installation-method auto
Correct Answer: AC

Which three parameters can be set when configuring a Cisco MDS 9000 Series Switch to use a TACACS+ server? 300-165 dumps (Choose three.)
A. group-size
B. deadtime
C. timeout
D. keep-alive
E. retransmit
Correct Answer: BCE

Which item represents the process that allows FCoE multihop using T11 standard FC-BB- 5?
A. distributed FCF
B. FIP proxy
C. N Port proxy
D. FIP snooping
Correct Answer: D

FIP snooping is used in multi-hop FCoE environments. FIP snooping is a frame inspection method that can be used by FIP snooping capable DCB devices to monitor FIP frames and apply policies based on the information in those frames.
This allows for:
Enhanced FCoE security (Prevents FCoE MAC spoofing.) Creates FC point-to-point links within the Ethernet LAN Allows auto-configuration of ACLs based on name server information read in the FIP frames.

Which two elements must be configured correctly for Cisco TrustSec Fibre Channel Link Encryption to work on a Cisco MDS 9000 Series Switch? (Choose two.)
B. key
C. salt
E. group
Correct Answer: BC

The Following Are Some Reviews From Our Customers:

300-165 dumps
You can click here to have a review about us:

Google Drive Latest Cisco 300-165 Dumps PDF:

Google Drive Latest Cisco 300-165 Dumps PDF:

Useful Cisco CCNP Data Center 300-165 dumps exam practice materials and study guides in PDF format free download from lead4pass. The best and most updated latest Cisco CCNP Data Center dumps pdf training resources which are the best for clearing 300-165 exam test, and to get certified by Cisco CCNP Data Center. 100% success and guarantee to pass Cisco 300-165 exam.

Best Cisco CCNP Data Center 300-165 dumps vce youtube demo:

Why Select Lead 4pass?

Lead4pass is the best provider of IT learning materials and the right choice for you to pass Cisco 300-165 exam. Other brands started earlier, but the questions are not the newest the price is relatively expensive. Lead4pass provide the latest real and cheapest questions and answers, help you pass Cisco 300-165 exam easily at first try.
300-165 dumps